FENIX LR80R - Rechargeable LED flashlight

The new ultra-powerful Fenix LR80R rechargeable flashlight delivers extreme light output of up to 18,000 lumens (ANSI) and a range of up to 1,130 meters. It achieves its performance with six high-end Luminus SST-70 LEDs with a 50,000-hour light life, powered by an internal high-current Li-ion battery with 86.4 Wh capacity.

The battery is recharged directly in the flashlight via a state-of-the-art USB-C connector with support for fast charging protocols. With the included 45W USB power supply, it charges in as little as four hours. The flashlight offers dual-button control to separately control high and low light modes, including two hidden flash modes, SOS and strobe.

Due to the huge light output, the flashlight is equipped with a proximity sensor in the reflector that automatically reduces the output to 50 lumens when the flashlight gets closer to an object than about 6-8 centimeters (prevents damage to the object from strong light and glare from reflected light).

The flashlight is equipped with five indicator LEDs that show the battery charge status. In addition, the flashlight can also be used as an emergency power bank to charge other USB devices. The flashlight has a removable handle in the basic package, on which a hanging eye and a tripod thread can be attached.

The flashlight can thus be carried in the hand, or with the help of a strap conveniently over the shoulder or mounted on a tripod and used as a stationary light. This searchlight is particularly suitable for rescue and reconnaissance operations. It is also well suited for surveillance of large objects or for all flashlight enthusiasts. It will delight both professionals and the most demanding users.

All flashlight parameters (luminous flux, battery life, waterproof, range and shockproof) are measured in accordance with ANSI/NEMA FL 1-2009.

Package contents: internal battery pack, 45W USB-C power adapter, USB-C charging cable, shoulder strap adapter and tripod thread, shoulder strap and replacement o-ring

Warranty: 5 years

Parameters:

• The light source is six modern Luminus SST-70 LEDs with a lifetime of 50,000 hours.
• Total of 10 lighting modes in two groups:
• Uses a high-current Li-ion battery built into the body with a capacity of 86.4 Wh (12000 mAh/7.2 V) for power.
• A fully discharged battery takes approximately 4 hours to charge with the included 45W USB-C power supply.
• USB output for charging external USB devices. For example, cell phone, GPS navigation and other portable electronics.
• Six-piece smooth parabolic reflector creates a light cone with extreme range up to 1130 meters
• The flashlight has memory and will always turn on in the last mode set within the mode group
• Status LEDs at the control buttons to indicate battery charge status
• Made of A6061-T6 aerospace hardened aluminum.
• Hard scratch resistant finish - Type III hard anodized.
• Resistant to drops from a height of 1 meter.
• Waterproof and dustproof to IP68 standard (tested underwater at a depth of 2 meters for 30 minutes).
• Hardened ultra clear glass lens with anti-reflective surface.
• Light-gauge threads with increased wear resistance.
• Capable of standing alone on a flat spot and serving as a candle.
• Solid metal handle for comfortable grip (removable).
• Scale can be threaded to screw onto a tripod or strap attachment.

Power Modes:
High Modes: 18000 lumens (2 hours)-> 12000 lumens (2.25 hours)-> 6000 lumens (2.8 hours)-> 3000 lumens (5.1 hours).
Low modes: 1000 lumens (15.7 hours) -> 450 lumens (39 hours) -> 150 lumens (92 hours) -> 50 lumens (300 hours) -> Strobe (6000 lumens) -> SOS (150 lumens).

Dimensions: 25.9 cm (length) x 5.4 cm (body diameter) x 10.8 cm (diameter at reflector)
Weight: 1639 grams (without batteries)
Material: aerospace hardened aluminum
Lumen output: 18000 lm
Range: 1130 m

Use
From the factory, there may be an insulating cap on the battery. Remove it before first use.
The flashlight control works in the form of two power groups. The right button controls the high power modes and the left button controls the low power modes and hidden flash modes.
Holding the left or right button for 0.5 seconds will turn the flashlight on to the last set power mode within the selected mode group (left button = low modes, right button = high modes). Pressing the left button then cycles through the 50 - 150 - 450 - 1000 lumen modes, and pressing the right button cycles through the 3000 - 6000 - 12000 and 18000 lumen modes.
Holding the right button for 1.2 seconds will always activate the highest 18000 lumen mode (even from off). Holding the left button for 1.2 seconds will switch the flashlight to strobe mode, then pressing the button again will switch to SOS. The flashlight is switched off by holding down any button for 0.5 seconds as when switched on.
The control buttons can be locked to prevent spontaneous switching on, e.g. when transporting in luggage - in the off state press both buttons and hold them for at least 3 seconds, then the flashlight will flash to indicate locking. To unlock, both buttons must be held down again for three seconds. Accidental switching on can also be prevented by loosening the body of the flashlight, thus breaking the electrical contact between the flashlight head and the battery.

Charging
Loosen the rubber cap of the charging connector and plug the cable into the USB-C connector on the flashlight, and plug the other end into the USB-C connector on the included charging adapter. The indicator LEDs on the flashlight flash from left to right during charging to indicate charging status. When charging is complete, all five indicator LEDs remain permanently lit. When charging is complete, seal the connector thoroughly with the rubber cap. During charging, the flashlight can only be used in the lowest mode with 50 lumens of power.
Charge external USB-C devices (powerbank function) - flip off the rubber cap of the USB connector and connect the device you want to charge with a suitable USB cable (only USB-C devices can be charged with the supplied cable). To activate the powerbank function, you need to briefly press one of the control buttons. Once charging has started, the indicator LEDs will start flashing from right to left to show the battery status. When charging is complete, be sure to properly seal the USB-C connector with the rubber cap. While using the powerbank function, the flashlight can be lit in all modes.
Battery charge status indication - after briefly pressing any button, the indication LEDs will light up for 3 seconds to show the battery charge status (the flashlight must be turned off). Five lit LEDs indicate that the battery is 80-100% charged, four lit 60-80%, three lit 40-60%, two lit 20-40% and one lit LED indicates that the battery is less than 20% charged.
Intelligent overheat protection - when the temperature exceeds 60°C, the flashlight will automatically reduce power in small increments to prevent overheating. Once cooled, it can be switched back to the highest power modes.
Proximity sensor in the reflector automatically reduces power to 50 lumens when the flashlight comes within 6-8 centimeters of an object (prevents damage to the object from strong light and glare from reflected light).

Caution
Do not disassemble the sealed parts of the flashlight yourself, it will violate the warranty.
If the protective rubber rings appear damaged after extended use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water.
If the flashlight blinks, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons:
The battery is dead, charge it.
The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol.
The body is loose, tighten it.