FENIX BC26R + BC05R V2.0 - bicycle flashlight

Discounted set of Fenix BC26R bike light and Fenix BC05R V2.0 flashlight.

The powerful Fenix BC26R rechargeable bike light delivers up to 1600 lumens (ANSI) with a range of up to 169 meters. It is powered by a replaceable Li-ion battery type 21700 with a capacity of 5000 mAh, which is included in the package and is charged via the USB-C connector directly in the flashlight. The light source is a modern Luminus SST-40 LED.

Specially designed optics create a very wide light cone that smoothly illuminates the entire area in front of the bike at an angle of 100°, so it shines even in places that ordinary bike lights do not cover. The bracket design allows for quick mounting and removal of the light on the handlebars without tools, and the bracket also allows for quick removal of the light so it can be used as a high-performance handheld light.

The holder can be used on all handlebar diameters from 22 to 32 millimetres. The Fenix BC26R offers a total of five digitally controlled power modes with up to 65 hours of runtime, and there's no shortage of flashing. Fenix bike lights provide you with quality lighting for night training, regular commuting and endurance racing.

All flashlight parameters (lumen output, battery life, waterproofing and range) are measured in accordance with ANSI/NEMA FL 1-2009.

Package contents: flashlight BC26R, rear flasher BC05R V2.0, universal handlebar mount, Fenix 21700 5000 mAh battery, USB-C cable, replacement sealing ring, rubber inserts for handlebar mount.

• A powerful Luminus SST-40 LED with a lifetime of 50000 hours is used.
• One Li-ion battery type 21700 5000 mAh is used for power supply (included)
• In an emergency, one 18650 Li-ion battery can also be used, but an ALF-18 reducer must be purchased for it
• Prolonged use of the highest power may cause the flashlight to heat up and activate the smart protection function
• Digital power control
• Low battery warning, overcharge and full battery protection
• Specially shaped optics create a light cone combining broad peripheral illumination
• The flashlight attaches to the holder with a quick-release mechanism
• Rubberised construction of the holder sleeve ensures a firm and secure fit
• Compatible with handlebars with a diameter of 22 to 32 millimetres
• Light direction can be adjusted in three lateral steps of approx. 30°
• Memory for the last set power mode (except flashing mode)
• Waterproof and dustproof to IP68 standard
• Shockproof against falls from a height of 1.5 metres

Five power modes in total: 1600 lumens (3.5 hours*) -> 600 lumens (9.5 hours) -> 200 lumens (18 hours) -> 50 lumens (65 hours) -> flashing (pulsing between 50 and 600 lumens).

Luminous flux: 1600 lm
Range: 169 m
Material: aerospace hardened aluminum A6061-T6
Dimensions: 11.3 x 2.9 x 2.7 cm
Weight: 155 g (including battery)

Using the bike light
There may be an insulating cap inside the battery pack from the factory. Remove it from the battery pack before first use.
To switch on or off, hold the side button for approximately 0.5 seconds. The flashlight will always turn on in the last set mode (except for flashing), you can switch other power levels at any time during operation by pressing the button. Press the button twice quickly to switch to flashing mode.
Battery capacity indication (only valid when powered by a 21700 Li-ion battery) - With the flashlight off, press the button once briefly, then the indicator LED next to the button will light for three seconds. A green light indicates the battery is more than 75% charged, a green flash indicates 75-50% charged, a red light indicates 50-25% charged and a red flash indicates less than 25% charged. The indicator LED also illuminates when the flashlight is on, so the user is kept informed of the battery status while driving.
Low Battery Warning - If the battery capacity drops below a safe level, the flashlight will automatically switch to lower power modes to ensure the longest battery life (the flashlight cannot be switched to higher modes afterwards). If the battery is critically low, the button will flash red. In this case, we recommend charging the flashlight as soon as possible to avoid turning off the protective electronics built into the batteries and thus turning off the light.
Intelligent overheating protection - after exceeding 60 °C, the flashlight will automatically gradually reduce power, after cooling down below this limit, the highest modes will be available again.

Charging
Unclip the rubber cap of the USB-C connector on the bottom of the flashlight and plug it into a computer, power bank, USB AC adapter or USB car adapter using the included USB cable.
The button glows red during charging, and glows green when fully charged.
Charging time is approximately 4 hours. The Li-ion battery used does not suffer from a memory effect, so the flashlight can be recharged at any time.
During charging, the flashlight can be used in an emergency, but only in the lowest 50 lumen mode.
After charging and removing the power cord, be sure to seal the USB-C connector cap.

Warning
Do not disassemble the sealed parts in the flashlight head yourself, it will violate the warranty. If the protective rubber rings appear damaged after extended use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water.
If the flashlight blinks, does not switch to higher modes, or does not light up, it may be due to one of the following reasons:
- The battery is almost dead, charge it or replace it.
- The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol.
- The battery cap is loose, tighten it.