Outdoorweb.eu

The Fenix HL45R zoom rechargeable headlamp delivers up to 1000 lumens (ANSI) of light and a range of up to 220 meters, plus a touchless on/off feature. The Gesture-sensing feature allows you to turn the light off and on by waving your hand in front of the headlamp (the feature can be deactivated). So you can keep your hands free of mud, oils and whatever while working and the flashlight stays clean at all times.

Power is provided by a 1900 mAh Li-ion battery that charges via the USB-C connector directly in the headlamp. The battery can be removed and replaced with three regular AAA batteries in an emergency (they cannot be recharged in the headlamp). The light source is a modern LED Luminus SFT-25R, its light is directed by special TIR (Total Internal Reflection) optics with the possibility of adjusting the width of the light cone(zoom function). In addition, it also has a red LED OSRAM GR QSSPA1.23, which achieves up to 130 lumens.

A total of 8 power modes are available, including a red flash mode for emergency situations. Despite the adjustable optics, the head torch retains its IP66 waterproof rating, so it can withstand heavy rain without problems. The headlamp strap is equipped with reflective elements that ensure good omnidirectional visibility when moving on the road.

Thanks to its features, the Fenix HL45R headlamp is suitable for work use, hiking, search and rescue work as well as a headlamp for running, camping, headlamp for fishermen and other activities.

All headlamp parameters (luminous flux, battery life, waterproof, range and shockproof) are measured in accordance with ANSI/NEMA FL 1-2009.

Package contents: headlamp, strap, ARB-LP1900 battery and USB charging cable.

Warranty: five years on the headlamp and two years on the battery.

1. It uses a powerful white Luminus SST-25R LED and a red OSRAM GR QSSPA1.23 LED with a 50,000-hour lifetime.
2. It can also be powered by 3x AAA batteries. It is possible to use disposable alkaline and rechargeable NiMH.
3. The strap with reflective elements increases passive safety, the double back increases the comfort of wearing on the head.
4. Waterproof and dustproof to IP66 standard (spraying with strong jets of water from all directions).
5. The headlamp comes with a rechargeable Li-ion battery ARB-LP1900 with a capacity of 1900 mAh.

• Four white light modes
• Four red light modes
• TIR optics with focusing function produces a cone with a range of up to 220 meters (12,067 cd).
• Four-diode battery charge indicator.
• Charging via USB-C connector.
• Convenient control via rotary switch with centre button.
• The headlamp can be tilted in the holder to set the desired direction of illumination.
• Made of durable plastic and aerospace grade aluminium alloy.
• Shockproof against falls from a height of 1 metre.
• Dimensions: 7,82 cm x 5 cm x 4,45 cm.
• Weight 133 grams (including battery and straps).

Four white light modes: 1000 lumens (3 hours) -> 350 lumens (4.33 hours) -> 130 lumens (12.6 hours) -> 30 lumens (54 hours).

Four red light modes: : 130 lumens (4.33 hours) -> 30 lumens (25.5 hours) -> 5 lumens (124 hours) -> 5 lumens flashing (240 hours).

Specifications:

Power: 1000 lm
Range: 220 m
Max battery life: 240 hrs
Power supply: ARB-LP1900
Number of modes: 8
Waterproof: IP66 (heavy rain)
Light color: Daylight white (5500-6500 K)
Light source: Luminus SFT-25R, OSRAM GR QSSPA1.23
Weight: 133 g

Use
There may be an insulating cap on the battery pack from the factory. Remove it before first use.
Switching on, off and switching modes - when the rotary switch is in the locked position, the headlamp is switched on by turning the switch. In the second position, it will turn on in white light mode, turning it to the third position will turn it on in red light mode. The power modes in each position are cycled by pressing a button on the side of the rotary switch. Holding the button for 0.5 seconds turns the headlamp off. If the headlamp is unlocked and turned off by the side button, it will turn back on by holding the side button for 0.5 seconds.
Headlamp gesture control - When the headlamp is on and the gesture sensing feature is activated, wave your hand within sensing range in front of the headlamp to temporarily turn it off and another wave of your hand to turn it back on. *When the headlamp is on and the gesture sensing function is activated, hold the side electronic switch for 0.5 seconds to turn the lamp off. After this action, it will not react to any motion operation.
Turning the gesture sensing function on and off - To turn the function on, press and hold the electronic switch for 6 seconds, the headlamp will flash red twice, indicating that the function is enabled. To turn the feature off, hold the side switch again for 6 seconds, the headlamp will flash red eight times, indicating the feature is disabled.

Note on the gesture sensing feature:
1. The sensing range is approximately 10 cm in front of the headlamp and may vary slightly depending on the material and color of the subject, ambient light, the brightness of the selected output, and the speed of the wave.
2If there are other objects in front of the headlamp in the sensing range, the lamp may also turn on or off.
3. The gesture sensing function only controls the switching on and off of the light and does not change modes.
4. When the gesture sensing function is activated, waving your hand will only turn the light off temporarily. At this time, the headlamp is in a low power standby state. If there is no activity for more than two hours, the headlamp will automatically switch off from standby and then cannot be switched on with a wave of the hand. To turn on, press and hold the electronic switch for 0.5 seconds or flip the switch.

Memory for last power mode set
If the headlamp was turned off with the side switch, it has a memory and will turn on in the last power mode set. With the exception of the highest white light mode, it will turn on in the second highest mode instead.

Battery charge indication
After a short press of the button (the headlamp must be switched off), the LED battery charge indicator is activated. Four lit LEDs indicate that the battery is 80-100% charged, three lit 60-80%, two lit 40-60%, one lit 20-40% and one flashing indicates that the battery is less than 20% charged. This feature is only available with the original ARB-LP1900 battery.

Charging
- Remove the dust cap and plug the USB Type-C charging cable into the charging port of the headlamp, after charging is complete, put the dust cap back on to ensure waterproof and dustproof.
- During charging, four indicators flash from left to right, four permanently on indicates charging is complete.
- Normal charging time is 3 hours with a 5V/1A USB adapter for a fully discharged headlamp.
- The headlamp can only be used in low mode while charging.

Caution
Do not disassemble sealed parts yourself, this will violate the warranty.
Use only the original Li-ion ARB-LP1900 battery, if using disposable AAA batteries, do not attempt to charge them in the headlamp.
If the headlamp blinks, does not switch to higher power modes or does not light up, it may be due to one of the following reasons. The contacts inside the headlamp are dirty - clean them with a cotton ball dipped in alcohol.