FENIX WF11E - professional flashlight

Professional flashlight Fenix WF11E with ATEX/IEC certification for use in explosive environments. The flashlight is powered by three AA batteries and provides up to 200 lumens.

The flashlight body is made of anti-static plastic (polycarbonate RTP399 x 133887) with high durability and shock resistance. In addition, the flashlight is equipped with a fixed clip with integrated magnet and magnetic end so that it can be attached to anything iron.

The flashlight is especially designed for firefighters and rescue workers, and is also suitable as a work flashlight for industrial facilities such as chemical plants, refineries, textile mills, paper mills and other facilities with increased risk of explosive gases and dust.

Certificates:

Useable in zones 0-2 explosive gases and zones 20-22 explosive dust
Full text of certificates:
IECEx: Ex ia IIC T4 Ga/ Ex ia IIIC T130°C Da IP66/IP67
ATEX: II 1G Ex ia IIC T4 Ga/II 1D Ex ia IIIC T130°C Da IP66/IP67
Also comes with CSA and PCEC certificates.

Package contents: three Energizer alkaline pencil batteries that are approved for use in the flashlight, spare o-ring, strap and EU valid certificate.

Warranty: 5 years

• Powerful Cree XP-G2 LED is used with a warmer shade of light with a lifetime of 50000 hours.
• Three power modes: 200 lumens (10 hours) -> 100 lumens (29.5 hours) -> 30 lumens (70 hours).
• Uses three pencil (AA) batteries. Fenix strongly recommends using only battery types that have been certified by the manufacturer: ENERGIZER E91, DURACELL MN1500 and RAYOVAC 815
• Protection against accidental insertion of the battery in reverse (reverse polarity).
• Made of solid anti-static plastic (polycarbonate RTP399 X 133887).
• Curved surface for better grip.
• Solid clasp with integrated magnet.
• Magnetic end cap.
• Proof and waterproof to IP67 standard to a depth of 1 metre underwater.
• Smooth aluminum reflector for a perfect light cone with a range of over 185 meters (8512 cd).
• Dimensions 16.75 cm (length) x 4.9 cm (head diameter) x 2.4 cm (body width).
• Weight 160 grams (without batteries).

Use:
The flashlight is turned on and off by holding the button on the side for 0.5 seconds. The light modes can be changed by briefly pressing the button in a low-medium-high cycle.
To change the batteries, unscrew the head of the flashlight and remove the battery holder. When replacing the batteries, observe the correct polarity marked on the holder. Replace the holder and screw the head of the flashlight back on.

Caution
Conduct all servicing and battery replacement outside of explosive atmospheres!
In explosive atmospheres, use only batteries that have been certified by the manufacturer: the ENERGIZER E91, DURACELL MN1500 and RAYOVAC 815
Never mix batteries from different manufacturers, of different ages or different discharge levels.
When storing batteries for long periods of time, we recommend removing them from the flashlight to avoid possible drainage and damage to the flashlight.
If the protective rubber rings appear damaged after prolonged use, replace them.
If the flashlight flickers, does not switch to higher power modes or does not light up, it may be due to one of the following reasons:
The batteries are almost dead - replace them.
The contacts inside the flashlight are dirty - clean them.
The flashlight body is loose, tighten it.