FENIX UC35 XP-L - Nabíjecí svítilna

The second generation of the Fenix UC35 V2.0 rechargeable tactical flashlight is equipped with the latest Cree XP-L HI V3 LEDs and delivers up to 1000 lumens (ANSI) and a range of up to 266 meters. Included in the package is a rechargeable 18650 Li-ion battery with a capacity of 3500 mAh, which charges directly in the flashlight via the side micro-USB connector. Alternatively, however, the flashlight can also be powered by two disposable CR123A batteries.

The UC35 flashlight features six different light modes, allowing you to choose between high power and long lasting. On the lowest moonlight mode, it can shine for up to 800 hours, which is more than 33 days. There are also strobe flashes for emergency situations.

The flashlight is powered by digitally regulated constant current to guarantee constant light output even when the battery voltage is reduced (when the batteries are slowly discharging). In addition, the flashlight is equipped with a battery charge indication in the side button.

The second generation of the Fenix UC35 V2.0 flashlight impresses not only with its smaller size and extended range, but also with a tactical switch and the possibility of attaching the AER-02 cable switch. We can therefore recommend it for use in security forces, hunting and other demanding activities. All flashlight parameters (luminous flux, battery life, waterproofness, range and shock resistance) are measured in accordance with ANSI/NEMA FL 1-2009.

• Uses top performance Cree XP-L HI V3 LED with a lifetime of 50000 hours
• The flashlight is equipped with intelligent overheat protectionDigitally regulated for constant brightness, low battery warning
• A rechargeable 18650 Li-ion battery can be purchased as a spare battery
Alternatively, two disposable CR123A lithium batteries can be used for power supply
• Protection against accidental reverse battery insertion (reverse polarity)
• Insensitive to drops from a height of 1 meter
• The flashlight has memory and always switches on in the last set mode (not valid for flash modes)
• Odd-numbered threads with increased wear resistance
• Substantial surface grooves for better grip, design prevents the flashlight from rotating on uneven surfaces
Waterproof and dustproof to IP68 standard
• Removable steel clip with titanium finish
• Hardened ultra clear glass lens with anti-reflective surface
• Smooth parabolic reflector for a light cone with a range of 266 meters (17700 cd)
• Tactical switch at the end of the flashlight (momentary on/off function)
• Can also be mounted on a long gun using the Fenix gun rail mount, magnetic mount
  
  

Power Modes:
Six light modes: Turbo 1000 lumens (2.25 hours) -> 350 lumens (4.1 hours) -> 150 lumens (10.6 hours) -> 50 lumens (28.1 hours) -> 1 lumen (800 hours) - Strobe 1000 lumens (variable frequency strobe).

Dimensions: 14.0 cm (length) x 2.54 cm (reflector diameter) x 2.35 cm (body diameter)
Weight: 89 grams (without batteries), 139 grams including battery
Material: T6, durable surface - Type III hard anodized

Use:
From the factory, there may be a black insulating cap inside the flashlight on the battery. Remove it from the battery pack before first use. Press the switch located on the end of the flashlight to turn it on, press the button for immediate activation. Press the side button at the head of the flashlight to switch between power modes at any time during operation. To switch to strobe mode, hold down the side button for approximately 0.5 seconds.
Intelligent overheat protection - if the temperature of the flashlight rises above 60°C, it will automatically begin to reduce power in gradual steps until its temperature stabilizes. As soon as the temperature of the lamp drops below 60°C, the power will automatically increase again to the original level. Operation at the highest power mode is thus not limited by time, but only by temperature.
Indication of the battery charge status - each time the lamp is switched on, the indication LED in the side button of the lamp is activated for three seconds. If the indicator LED is green the battery is more than 85% charged. Green flashing indicates 50-85% capacity. If it glows red, it is 25-50% charged. Red blinking indicates that less than 25% of the battery capacity is left (works only when using a 18650 Li-ion battery).
Charging - Unclip the rubber cap of the charging connector on the side of the flashlight and plug in the included cable (micro USB connector), plug the other end of the cable into a computer, or a USB adapter to the mains or car. During charging, the side button lights up red. When fully charged, it will light up green. Charging a fully discharged battery takes approximately 3.5-4 hours. During charging, the flashlight can be used, but only in the 50 lumen light mode.
Warning of low battery - the flashlight will gradually switch automatically to the lowest mode and the indicator LED in the side button will start flashing red.

Warning
Do not disassemble the sealed parts in the flashlight head yourself, it will break the warranty..
If disposable CR123A batteries are used, do not attempt to charge them in the flashlight.
If the protective rubber rings appear damaged after extended use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water.
If the flashlight flickers, does not switch to higher power modes or does not light up, it may be due to one of the following reasons:
The batteries are almost dead - replace them or charge the battery.
The contacts inside the flashlight are clogged - clean them with a cotton swab dipped in alcohol.
The head, body or back of the flashlight is loose - add lubricant to the sealing rings and tighten both the head and the end of the flashlight firmly.