FENIX LD12 (320 lumenů) - LED flashlight

The fourth generation of the Fenix LD12 flashlight can be powered by a single AA pencil battery or a 14500 Li-ion battery, offering up to 320 lumens (ANSI) and a range of 135 meters. An advanced Cree XP-G2 R5 LED with a warmer light tint is used as the light source. The flashlight has five different lighting modes that allow you to choose between high power and long lasting (up to 60 hours).

The flashlight is powered by digitally regulated constant current to guarantee a constant light output even when the voltage in the batteries is reduced (when they are slowly discharging). The Fenix LD12 is a universal handheld flashlight suitable for everyday carry, the outdoors or hiking.

• The flashlight's performance is measured in accordance with ANSI/NEMA FL 1-2009
• Powerful Cree XP-G2 R5 LED with a warmer light tint and a 50,000-hour lifespan
• Five power modes
• Digitally controlled for constant brightness
• Smooth aluminum reflector for a light cone with a range of over 135 meters
• One standard pencil battery (AA type - alkaline, lithium or rechargeable NiMH)
• Can be used for powerOne Li-ion battery type 14500 can also be used
• Protection against accidental insertion of the battery in reverse (reverse polarity)
• Insensitive to falls from a height of min. 1 metre
• Switch-on memory always in last set mode
• Switchable to strobe
• Bottom surface - Type III hard anodized
• Pronounced knurling across the entire surface of the flashlight for better grip
• Design prevents the flashlight from rotating on uneven surfaces
• Resistant and waterproof to IP68 standard
• Resistant and waterproof to IP68 standard
• Resistant to IP68 standard/li>
• Hardened ultra-clear glass lens with anti-reflective surface
• Removable clasp with titanium finish
• Odd-shaped threads with increased wear resistance
• Tactical switch at the end of the flashlight (instant on/off function)

Power Modes:
Measured with a 14500 Li-ion battery with 800 mAh capacity: 320 lumens (1 hour) -> 70 lumens (3.5 hours) -> 30 lumens (11 hours) -> 5 lumens (50 hours) -> Strobe (flash mode)
Measured with a 2500 mAh AA NiMH battery: 150 lumens (1.75 hours) -> 70 lumens (5.7 hours) -> 30 lumens (13 hours) -> 5 lumens (60 hours) -> Strobe (flash mode)
Measured with included alkaline AA battery: 150 lumens (0.8 hours) -> 70 lumens (3 hours) -> 30 lumens (9.7 hours) -> 5 lumens (40 hours) -> Strobe (flash mode)

Material: T6 aerospace-grade hardened aluminum
Dimensions: 10.25 cm (length) x 2.15 cm (body diameter) x 2.05 cm (head diameter)
Weight: 56 grams (without battery)
Luminous flux: 320 lm
Range: 135 m

Use
To turn on, press the switch located at the end of the flashlight, for instant activation press the button. Press the side button at the head of the flashlight to switch between power modes at any time during operation. To switch to strobe mode, hold the side button for approximately 1 second.

Caution
Do not disassemble the sealed part in the flashlight head yourself, it will void the warranty. Remove the batteries from the flashlight if you will not be using it for an extended period of time or if the battery is already dead. This will prevent damage to the flashlight, e.g. by a leaking battery. If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power modes or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The contacts inside the flashlight are clogged - clean them with a cotton swab dipped in alcohol. The head, body or back of the flashlight is loose - add lubricant to the sealing rings and tighten both the head and the end of the flashlight firmly.