FENIX E35 Ultimate Edition (1000 lumenů) - LED flashlight

The second generation of the Fenix E35 Ultimate Edition LED flashlight offers up to 1000 lumens (ANSI). Excellent performance has been achieved by using the advanced Cree XM-L2 U2 LED. A high-capacity 18650 li-ion battery or two disposable CR123A batteries can be used to power the flashlight.

The flashlight has been designed with ease of use and broad usability in mind. The seven light functions allow you to choose between high power and more than six days of runtime, and two flash modes are available. The Fenix E35 UE is powered by digitally controlled constant current to guarantee a constant light output even when the battery voltage is reduced (when the batteries are slowly discharging).

Both switching on and switching modes are done by two buttons ergonomically placed on the side. This flashlight is an ideal light tool with an excellent ratio of high performance, quality and price. All flashlight parameters (lumen output, battery life, waterproof, range and shockproof) are measured in accordance with ANSI/NEMA FL 1-2009.

• Premium Cree XM-L2 U2 LED with a 50,000 hour lifetime
• Seven power modes
• Digitally controlled for constant brightness
• Operation in 1000 lumen mode is limited to 5 minutes at a time
• The flashlight is shockproof against drops from a height of 1 meter.
• Accidental reverse battery insertion protection (reverse polarity)
• Bottom surface - Type III hard anodized
• Substantial surface grooves for better grip
• The flashlight has memory and always turns on in the last mode setting
• Overheat protection
• Hardened ultra-clear glass lens with anti-reflective surface
• Batteries not included
• Five Year Warranty.

Power Modes:
1000 lumens (1.9 hours) -> 450 lumens (4 hours) -> 150 lumens (11.9 hours) -> 50 lumens (42.5 hours) -> 8 lumens (150 hours) - Strobe (1000 lumens) -> SOS (150 lumens).

Use
of the Fenix E35 Ultimate Edition LED Flashlight The flashlight is controlled by two buttons on the side. Holding down the bottom button for 0.5 seconds puts it into steady light mode, you can change the light output at any time during operation by pressing this button again. Holding the top button for 0.5 seconds will switch the torch into flash modes, you can then switch between strobe and SOS by pressing this button again. To turn the flashlight off, hold down either button for 0.5 seconds. To lock the buttons: if you want to prevent the torch from being switched on unintentionally in your luggage, press both buttons for 3 seconds, the torch will then flash twice in low mode and cannot be switched on. To unlock, hold both buttons again for 3 seconds.

Caution
Do not disassemble the sealed part in the head of the flashlight yourself, it will violate the warranty. Use only high quality CR123A batteries or 18650 batteries to avoid damaging the flashlight, for example due to battery leakage. If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power, or does not light up, it could be one of the following reasons The batteries are almost dead - replace them. The contacts inside the flashlight are clogged - clean them with a sponge dipped in alcohol. The body of the flashlight is loose, tighten it.

Material: T6 aerospace hardened aluminium
Dimensions: 12.2 cm (length) x 2.4 cm (diameter)
Weight: 72 grams (without batteries)
Luminous flux: 1000 lumens
Range: 160 m