FENIX E25 Ultimate Edition - LED flashlight

The Fenix E25 Ultimate Edition LED flashlight can be powered by two AA pencil batteries or two 14500 li-ion batteries, offering up to 1000 lumens (ANSI). The light source is a high-end Cree XP-L diode that, combined with a smooth reflector, can illuminate up to 200 metres.

Seven light functions allow you to choose between high power and up to four days of runtime, and two flash modes are available. The Fenix E25 is powered by a digitally controlled constant current to guarantee a constant light output even when the battery voltage is reduced (when the batteries are slowly discharging).

Control is via two buttons ergonomically positioned on the side. This flashlight is an ideal light tool with an excellent ratio of high performance, quality and price. All flashlight parameters (lumen output, battery life, waterproof, range and shockproof) are measured in accordance with ANSI/NEMA FL 1-2009.

• Cree XP-L LED with 50,000 hour lifetime
• Continuous light modes
• Digitally regulated for constant brightness
• Overheat protection
• Protection against accidental insertion of the battery in reverse (reverse polarity)
• Insensitive to falls from a height of 1 meter.
• Bottom surface - Type III hard anodized
• Substantial surface grooves for better grip
• Last set mode power-on memory
• Waterproof to IPX-8 standard
• Hardened ultra clear glass lens with anti-reflective surface
• Range up to 200 meters using 14500 li-ion
• Range 118 meters using AA batteries

Power Modes:
Measured with Fenix 14500 li-ion batteries: 1000 lumens (0.8 hours) -> 350 lumens (2.25 hours) -> 160 lumens (5 hours) -> 50 lumens (16.5 hours) -> 5 lumens (95 hours)
Measured with included alkaline AA batteries: 350 lumens (0.8 hours) -> 160 lumens (2.2 hours) -> 50 lumens (13 hours) -> 5 lumens (90 hours)
Measured with 2500 mAh NiMH AA batteries: 350 lumens (1.5 hours) -> 160 lumens (4.5 hours) -> 50 lumens (13.5 hours) -> 5 lumens (100 hours)

Use
The flashlight is operated by two buttons on the side. Press the bottom button to turn it on in steady light mode, you can change the light output at any time during operation by pressing this button again. Pressing the top button switches the torch into strobe modes, you can then switch between strobe and SOS by pressing this button again. To turn the flashlight off, hold down either button for 0.5 seconds. To lock the buttons: if you want to prevent the torch from being switched on unintentionally in your luggage, press both buttons for 3 seconds, the torch will then flash twice in low mode and cannot be switched on. To unlock, hold both buttons again for 3 seconds.

Caution
Do not disassemble the sealed part in the head of the flashlight yourself, it will violate the warranty. Remove the batteries from the flashlight if you will not be using it for an extended period of time, or if the batteries are already dead. Disposable batteries may leak and damage the flashlight. If the protective rubber rings appear damaged after extended use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power, or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol. Flashlight body is loose - tighten it.

Overheat protection
Operation in 1000 lumen mode is limited to 3 minutes at a time, operation in 350 lumen mode is limited to 10 minutes at a time. When the time limit is exceeded, the flashlight will reduce the power output one notch lower.

Material: T6 aircraft-grade hardened aluminum
Dimensions: 16.1 cm (length) x 1.96 cm (body diameter) x 2.54 cm (head diameter)
Weight: 87 grams (without batteries)
Lumen output: up to 1000 lumens
Range: 200 m