FENIX LD02 - Flashlight

The FENIX LD02 flashlight is extremely small, but highly powerful - offering a light output of up to 100 lumens (ANSI). It is fitted with a powerful Cree XP-E2 LED and is not much bigger than the micro battery (AAA battery) from which it is powered. The LD02 features three different light levels, allowing users to choose the most appropriate compromise between light intensity and runtime.

The Fenix LD02 uses commonly available micro-pin batteries and its almost negligible size and weight make it ideal for Everyday Carry (EDC) use. If you are looking for a solid, reliable and powerful flashlight in the smallest size possible, then the Fenix LD02 is for you. All flashlight parameters (lumen output, battery life, waterproof, range and shock resistance) are measured in accordance with ANSI/NEMA FL 1-2009.

• Powerful Cree XP-E2 LED with a 50,000 hour lifetime
• Three power levels
• Uses only one micro-rechargeable battery (AAA type - alkaline, lithium or rechargeable NiMH)
• Batteries are inexpensive and widely available
• Battery voltage supported 0.9-1.7V
• Bottom surface - Type III hard anodized
• Shockproof against drops from a height of 1 meter
• Waterproof to IPX-8 standard
• Hardened ultra clear glass lens with anti-reflective surface
• Collimator produces a smooth light cone with a range of 45 meters
/li>
• Solid steel clasp with titanium finish (removable)
• Turn on and mode switch with limit switch
• Warranty Five year warranty.

Power Modes:
100 lumens (0.75 hours)-> 25 lumens (4.25 hours)-> 8 lumens (15 hours)

Dimensions: 7.6 cm (length) x 1.5 cm (diameter)
Weight: 16 grams (without batteries)
Material: aerospace-grade hardened aluminum
Lumen output: 100 lm
Range: 45 m

Use
Fenix LD02 Flashlights To turn on, press the switch located on the end of the flashlight. The flashlight will always turn on to the medium 25 lumen mode. With the flashlight on, you can change power modes at any time by pressing the button (cycles through medium - low - high). Overheat protection - after 3 minutes of operation on the highest power, the flashlight will switch to the second mode.

Warning
Do not disassemble the sealed part in the flashlight head yourself, it will violate the warranty. Use only high quality micro-charge batteries to avoid damaging the flashlight, for example due to battery leakage. Remove the batteries from the flashlight if it will not be used for a long period of time or if the battery is already discharged. Insert the battery with the positive pole towards the head of the flashlight. If the protective rubber rings appear damaged after extended use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The head of the flashlight is loose, tighten it. The contacts inside the flashlight are clogged - clean them with a sponge dipped in alcohol.