FENIX E02R černá - Rechargeable LED flashlight

The Fenix E02R is a miniature rechargeable flashlight that can be worn, for example, on your keys. Despite its minimal size, it offers a light output of up to 200 lumens (ANSI) and a range of up to 49 meters. It is powered by a Li-polymer battery that charges via the included micro-USB connector.

Two intensity modes are available with up to 6.5 hours of runtime. The flashlight is switched on by tightening the head. A light tightening turns on low power (15 lumens) and a stronger tightening turns on high power (200 lumens). Thanks to its light weight and very small size, you can always have your flashlight at hand. In addition, you can choose from three color options (black, blue and brown).

All flashlight parameters (lumen output, battery life, waterproofing and range) are measured in accordance with ANSI/NEMA FL 1-2009.

Included: replacement o-ring, steel ring for hanging on keys, micro-USB charging cable.

• A white Cree XP-G2 S3 LED with a 50,000 hour lifetime is used.
• Two light modes: 200 lumens (25 minutes)-> 15 lumens (6.5 hours).
• The flashlight is powered by a built-in 120 mAh Li-pol battery.
• Charges via micro-USB connector.
• Three colors (black, blue,brown).
• Highly efficient TIR collimator produces a light cone with a range of up to 49 meters (591 cd).
• Resistant to drops from a height of 1 meter.
• Hard scratch-resistant anodization - Type III hard anodized.
• Protection against damage from reversed battery insertion (reverse polarity).
• Waterproof and dustproof to IP68 standard

Power Modes:
Two light modes: 200 lumens (25 minutes)-> 15 lumens (6.5 hours).

Lumen: 200 lm
Range: 49 m
Weight: 15 g (including battery)
Dimensions: 4.8 cm (length) x 1.5 cm (diameter)

Use
The flashlight is switched on by tightening the head. Tightening it slightly turns on low power (15 lumens) and tightening it more firmly turns on high power (200 lumens). Loosening the head switches the torch off. Do not tighten the flashlight head 'to blood', this may cause the flashlight to turn off or flicker.

Charging
1. Unscrew the flashlight head and plug the cable into the micro-USB connector. You can use a USB AC adapter or USB car adapter to charge the lamp, or you can use any cell phone charger with a micro-USB connector or power bank.
2. During charging, the indicator LED on the electronics glows red, after a full charge it glows green.
3. Charging time for a fully discharged battery is approximately 60 minutes.
4. The Li-pol battery used does not suffer from memory effect, so the flashlight can be recharged at any time.

Caution
Do not disassemble the sealed parts yourself, it will violate the warranty.
If the flashlight does not switch to higher power modes or does not light up, the battery is dead - charge the flashlight.