FENIX TK75 4xCree XHP35 HI + 4x akumulátory 3500 mAh - Rechargeable LED flashlight

A bargain set of the Fenix TK75 Cree XHP35 HI flashlight and four Fenix 18650 3500 mAh rechargeable Li-ion batteries. Save 496 Kč! The batteries are rechargeable and can be charged directly in the flashlight, so you don't have to take them out in a complicated way.

Now in its fourth generation, the extremely powerful Fenix TK75 flashlight delivers an increased lumen output of up to 5100 lumens (ANSI) and a range of up to 850 meters. Four state-of-the-art Cree XHP35 HI LEDs are used as the light source. Using modern 18650 li-ion batteries, the flashlight is surprisingly compact at just 18.8 centimeters in length.

The flashlight offers a total of eight constant power levels, including two strobe flash modes and SOS. For convenient operation, the flashlight is equipped with two buttons on the side.

In addition to the previous version, the option of charging the batteries via micro USB directly in the battery holder has been added. This searchlight is suitable for applications such as reconnaissance and rescue operations, for moving in difficult and impenetrable terrain and for all who demand the highest performance. All flashlight parameters (lumen output, battery life, waterproof, range and shock resistance) are measured in accordance with ANSI/NEMA FL 1-2009.

• Four state-of-the-art Cree XHP35 HI LEDs with a 50,000 hour life span
• Five power modes in total
• Battery charge status indication
• Chargerable via micro USB connector in battery holder
• 4x 18650 li-ion batteries can be used for power
• PowerIn case of emergency, half the number of 18650 batteries can be used
• Option to purchase an extension kit and power it from multiple 18650 batteries
• Eight disposable CR123/CR123A batteries can be used for emergency power
• Eight disposable CR123/CR123A batteries can be used for power/li>
• Digitally controlled for constant brightness
• Intelligent overheat protection
• Four-piece smooth parabolic reflector creates a light cone with a range of up to 850 m
/li>
• Protection against too deep battery discharge
• Memory to turn on in the last set mode
• Protection against accidental reverse battery insertion (reverse polarity)
/li>
• Hard scratch-resistant surface - Type III hard anodized
• Resistant to drops from a height of 1 meter
• Waterproof to IPX-8 standard
• Tempered ultra-clear glass lens with anti-reflective surface
• Flat threads with enhanced wear resistance
• Able to stand alone on a flat surface and serve as a candle
/li>
• Body is threaded for mounting on a tripod
• Significant knurling across the entire surface of the flashlight for better grip

Power Modes:
Five power modes: 5100 lumens (2.25 hours) -> 2000 lumens (3 hours) -> 1000 lumens (6 hours) -> 450 lumens (17.75 hours) -> 150 lumens (46 hours) ->.gt; 50 lumens (95 hours) -> Strobe 5100 lumens (variable frequency strobe) -> SOS 150 lumens (270 hours).

Dimensions (length x body diameter x diameter at reflector): 18.8 x 5.3 x 8.6 cm
Weight: 630 g (without batteries)
Material: aerospace aluminum
Head material: stainless steel striking rim
Range: 850 m
Luminous flux: 5100 lm

Use
Hold down the right button to turn the flashlight on, and press again to switch between constant power modes. Press the left button to activate the strobe and another press to activate the SOS mode. You can get back to the last steady light mode by pressing the right button. Holding down the right button for 1.2 seconds will turn the flashlight straight into Turbo mode at 5100 lumens (when the flashlight is off). Holding down the left button for approx. 0.5 seconds will switch the flashlight directly into strobe mode.

Battery capacity indication (only valid when powered by 18650 li-ion batteries)
After briefly pressing the left button (flashlight must be off), the LED indicator between the buttons will activate for three seconds. If the indicator LED is green the battery is more than 80% charged. Green flashing indicates 50-80% capacity. If it is red, the battery is charged to 20-50%. Red flashing indicates less than 20% battery capacity remaining. You can also check the battery charge status by pressing the blue button on the top of the battery holder.

Charging
Remove the battery holder from the flashlight and plug the included cable into the flashlight (micro-USB connector), plug the other end of the cable into your computer or a USB mains or car adapter (not included). The LED on the holder lights up red during charging and turns green when fully charged. Low battery warning - the indicator between the buttons lights up red. The flashlight then automatically switches to the lowest mode gradually. The control buttons can be locked to prevent spontaneous switching on, e.g. when transporting in luggage - hold both buttons down for 3 seconds. To unlock, hold both buttons again for 3 seconds. Intelligent overheat protection - if the temperature of the flashlight rises above 65°C, it will automatically switch to a lower level.

Warning
Do not disassemble the sealed parts of the flashlight yourself, it will violate the warranty. Use only high quality 18650 batteries and CR123A batteries to avoid damaging the flashlight, for example due to battery leakage. If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power modes, or does not light up it may be due to one of the following:
Batteries are almost dead - replace them.
The contacts inside the flashlight are clogged - clean them with a cotton swab dipped in alcohol.
The body or back of the flashlight is loose - add lubricant to the sealing rings and tighten.