FENIX TK25 Red - Tactical LED flashlight

The powerful Fenix TK25 Red tactical flashlight offers a peak light output of up to 1000 ANSI lumens of white light, plus two red LEDs with up to 310 lumens and a range of 200 meters. The very rugged and waterproof design and dual-layer body construction make this tactical flashlight destined for harsh outdoor conditions, for professionals, armed forces and hunting.

The Fenix TK25 Red flashlight uses a dual tactical switch that allows for faster and more reliable control in crisis situations. For example, it can be easily switched directly into strobe mode. The flashlight is powered by a digitally controlled constant current to guarantee a constant light output even when the battery voltage is reduced (when the batteries are slowly discharging).

Two 3V CR123A lithium batteries or one rechargeable high-capacity Li-ion battery 18650 can be used for power.

Fenix TK25 Red features a total of five white light modes with up to 110 hours of runtime and three red light modes.

Switching between white and red light modes is very easy, just rotate the flashlight head 90°. However, due to the magnetic sensors in the head of the flashlight, it cannot be used with a magnetic gun mount, which interferes with its proper function.

All flashlight parameters (luminous flux, battery life, waterproofness, range and shock resistance) are measured in accordance with ANSI/NEMA FL 1-2009.

Package Contents: Wrist lanyard, belt pouch and replacement o-rings. Batteries not included.

Warranty: 5 years

Parameters:

• Two white powerful Cree XP-G2 S3 LEDs with a lifetime of 50000 hours
• Two Cree XP-E2 color LEDs (blue and red)
• Five white light output modes
• Three red light modes
• Double aluminium reflector with a range of up to 225 metres
• Two 3V CR123A lithium batteries can be used for power supply
• High capacity rechargeable 18650 Li-ion battery can also be used for power
• Electronics with digital constant power control
• Back-insert protection
• System of two springs - high durability of the flashlight when used on a weapon
• Intelligent overheat protection
• Maximum mode operation limited only by flashlight temperature - not time
• Resistant to drops from a height of 1 metre
• Highly wear-resistant low-mast threads
• Memory to turn on always in last mode - no strobe
• Low scratch resistant surface - Type III hard anodized
• Waterproof and dustproof to IP68 standard
• Hardened ultra clear glass lens with anti-reflective surface
• Dual tactical switch at the end of the flashlight (instant on/off function)
• Solid clip for safe and easy carrying of the flashlight (removable)
• The flashlight does not slip in the hand and does not rotate when put down

Power Modes:
Five white light power modes: 1000 lumens (2 hours)-> 300 lumens (5.3 hours)-> 100 lumens (22.3 hours)-> 15 lumens (110 hours)-> strobe (strobe flash).
Three red light modes: 310 lumens/5500mW (2.5 hours) -> 100 lumens (9.3 hours) -> 10 lumens (100 hours)

Dimensions: 14.26 cm (length) x 4 cm (head diameter) x 2.5 cm (body diameter)
Weight: 156.5 grams (without batteries)
Material: aerospace hardened aluminum
Lumen output: 1000 lm
Range: 225 m

Controls
Press the larger button located on the end of the flashlight to turn on, press the button to activate immediately. Press the adjacent toggle button to switch between power modes at any time during operation. To switch to flash mode with the flashlight on, hold the toggle button for approximately 1 second. To turn the flashlight directly into strobe mode, press and hold the toggle button. Switch between white and coloured light modes by turning the flashlight head 90°. The coloured light will always start in red 150 lumens mode. You can switch between the colour modes again with the second smaller button. Intelligent overheat protection - if the temperature of the flashlight rises above 65°C, it will automatically start to reduce power in gradual steps of 5% every 30 seconds until its temperature stabilizes. Once the temperature of the lamp drops below 65°C, the power will automatically increase again to the original level. Operation at the highest power mode is thus not limited by time, but only by temperature.

Caution
Use only high quality 3V CR123A batteries and 18650 li-ion batteries to avoid damage to the flashlight, for example due to battery leakage. Insert the batteries with the positive pole towards the head of the flashlight. If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol. The head, body or back of the flashlight is loose - tighten them.