FENIX TK25 R&B - Tactical LED flashlight

The powerful Fenix TK25 R&B tactical flashlight offers a peak light output of up to 1000 ANSI lumens of white light plus two color LEDs (red and blue). Switching between white and colored light mode is very easy, just rotate the flashlight head 90°. The very solid and waterproof design and the double-layered body construction predestines this tactical flashlight for harsh outdoor conditions, for professionals, armed forces and hunting.

The Fenix TK25 R&B flashlight uses a dual tactical switch that allows for faster and more reliable control in crisis situations. For example, it can easily be switched directly into strobe mode. The flashlight is powered by a digitally controlled constant current to guarantee a constant light output even when the battery voltage is reduced (when the batteries are slowly discharging).

The Fenix TK25 R&B has a total of five white light modes with up to 110 hours of operation and three coloured light modes. All flashlight parameters (lumen output, battery life, waterproof, range and shockproof) are measured in accordance with ANSI/NEMA FL 1-2009.

• Two white Cree XP-G2 S3 power LEDs with a 50,000-hour lifetime
• Two colored Cree XP-E2 LEDs (blue and red)
• Five white light output modes
• Three color light modes
• Double aluminum reflector with a range of up to 225 meters
• Two 3V CR123A lithium batteries can be used for power supply
• High capacity rechargeable 18650 Li-ion battery can also be used for power
• Electronics with digital constant power control
• Reverse battery insertion protection
• Two spring system - high durability of the flashlight when used on a gun
• Intelligent overheat protection
• Resistant to drops from 1 meter
• Highly wear-resistant low-mast threads
• Memory to turn on always in last mode - no strobe
• Hard scratch resistant surface - Type III hard anodized
• Waterproof and dustproof to IP68 standard
/li>
• Hardened ultra clear glass lens with anti-reflective surface
• Dual tactical switch on the end of the flashlight (instant on/off function)
• Solid clip for safe and easy carrying of the flashlight (removable)
• The flashlight does not slip in the hand and does not twist when put down
• Warranty Five year warranty.

Power Modes:
Five white light power modes: 1000 lumens (2 hours) -> 300 lumens (5.3 hours) -> 100 lumens (22.3 hours) -> 15 lumens (110 hours) -> strobe (strobe flash).
Three color light modes: red 150 lumens (7.5 hours) -> red 25 lumens (40 hours) -> blue 60 lumens (6.6 hours)

Dimensions: 14.26 cm (length) x 4 cm (head diameter) x 2.5 cm (body diameter)
Weight: 156.5 grams (without batteries)
Material: Aerospace hardened aluminum
Luminous flux: 1000 lm
Range: 225 m

Controls
To turn on, press the larger button located on the end of the flashlight, to activate immediately, press the button. Press the adjacent toggle button to switch between power modes at any time during operation. To switch to flash mode with the flashlight on, hold the toggle button for approximately 1 second. To turn the flashlight directly into strobe mode, press and hold the toggle button. Switch between white and coloured light modes by turning the flashlight head 90°. The coloured light will always start in red 150 lumens mode. You can switch between the colour modes again with the second smaller button. Intelligent overheat protection - if the temperature of the flashlight rises above 65°C, it will automatically start to reduce power in gradual steps of 5% every 30 seconds until its temperature stabilizes. Once the temperature of the lamp drops below 65°C, the power will automatically increase again to the original level. Thus, operation at the highest power mode is not limited by time, but only by temperature.

Caution
Use only high quality 3V CR123A batteries and 18650 li-ion batteries to avoid damage to the flashlight, for example due to battery leakage. Insert the batteries with the positive pole towards the head of the flashlight. If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol. The head, body or back of the flashlight is loose - tighten them.