FENIX TK25 IR - Tactical LED flashlight

The powerful Fenix TK25 IR tactical flashlight offers a peak lumen output of up to 1000 ANSI lumens of white light, plus two infrared LEDs with a wavelength of 850 nm and a maximum output of 3000 mW. This wavelength is compatible with most night vision systems. Switching between white and infrared light mode is very easy, just rotate the flashlight head 90°.

The very solid and waterproof design and double-layer body construction makes this tactical flashlight suitable for harsh outdoor conditions, for professionals, armed forces and hunting. The Fenix TK25 IR flashlight uses a dual tactical switch that allows for faster and more reliable control in crisis situations. For example, it can be easily switched directly into strobe mode.

The flashlight is powered by digitally controlled constant current to guarantee constant light output even when the battery voltage is reduced (when the batteries are slowly discharging). The Fenix TK25 IR features a total of five white light modes with up to 110 hours of runtime and two infrared light modes.Included in the package is a swivel case designed for quick and easy removal of the flashlight.

• Light measured in accordance with ANSI/NEMA FL 1-2009
• Two white Cree XP-G2 S3 powerful LEDs with a 50,000 hour lifetime
• Two infrared LEDs with 850 nm wavelength light and a maximum output of 3000 mW
• Five white light power modes
• Two infrared light modes
• Double aluminum reflector with a range of over 225 meters
• /li>
• Two 3V CR123A lithium batteries can be used for power
• One rechargeable high capacity 18650 Li-ion battery can also be used for power
• Electronics with digital constant power control
• Backward battery protection
• Two spring system - high resistance of the flashlight when used on a gun
• Overheat protection
• /li>
• After 20 minutes of operation at full power, the flashlight switches to a lower mode
• Resistant to falls from a height of 1 meter
• Highly wear-resistant low-mast threads
• /li>
• Memory to turn on always in last mode - no strobe
• Bottom heavy scratch resistant surface - Type III hard anodized
• Waterproof and dustproof to IP68 standard
• /li>
• Hardened ultra clear glass lens with anti-reflective surface
• Dual tactical switch on the end of the flashlight
• Batteries not included
• Sturdy clip for safe and easy carrying of the flashlight (removable)
• The flashlight, due to its design, does not slip in the hand and does not twist when put down

Power Modes:
Five white light output modes: 1000 lumens (2 hours) -> 300 lumens (5.3 hours) -> 100 lumens (22.3 hours) -> 15 lumens (110 hours) -> strobe (strobe flash).
Two infrared light modes: 3000 mW and 1000 mW

Dimensions: 14.26 cm (length) x 4 cm (head diameter) x 2.5 cm (body diameter)
Weight: 156.5 grams (without batteries)
Material: Aerospace-grade hardened aluminum
Lumen output: 1000 lm
Range: 225 m

Controls
To turn on, press the larger button located on the end of the flashlight, to activate immediately. Press the adjacent toggle button to switch between power modes at any time during operation. To switch to flash mode with the flashlight on, hold the toggle button for approximately 1 second. To turn the flashlight directly into strobe mode, press and hold the toggle button. Switch between white and infrared modes by turning the flashlight head 90°. Removing the clip - unscrew the tactical ring and pull the clip off the flashlight body, screw the tactical ring back on.

Caution
Use only high quality 3V CR123A batteries and 18650 li-ion batteries to avoid damage to the flashlight due to, for example, battery leakage. Insert the batteries with the positive pole towards the head of the flashlight. If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol. The head, body or back of the flashlight is loose - tighten them.