FENIX FD20 - Focusing flashlight

The Fenix FD20 zoom flashlight offers a high lumen output of up to 350 lumens (ANSI) and a range of up to 115 meters. The flashlight offers simple operation and four levels of light output with up to 80 hours of run time. The focal width of the light cone is controlled by turning a ring on the flashlight barrel. Despite the adjustable optics, the flashlight maintains full IP68 waterproofness down to a depth of two meters underwater.

Operation and switching is handled by a push-button end. It uses two commercially available AA pencil batteries for power, of course disposable and rechargeable batteries can be used. Thanks to the electronics with constant current regulation, it provides a constant light output even when the voltage in the batteries is reduced (when they are slowly discharging).

This flashlight is an ideal light tool with an excellent ratio of high performance, quality and price. All flashlight parameters (luminous flux, battery life, waterproof, range and shock resistance) are measured in accordance with ANSI/NEMA FL 1-2009.

• Modern Cree XP-G2 S3 LED with 50,000 hours of life
• Four power modes
• Uses two pencil batteries (AA type - alkaline, lithium or rechargeable NiMH)
/li>
• Batteries are inexpensive and widely available
• Protection against accidental reverse battery insertion (reverse polarity)
• Special moving reflector creates a focusable cone with a range of 48-115 m
• Insensitive to drops from a height of 1 meter
• Bottom surface - Type III hard anodized
• Significant surface striations for better grip
• The flashlight has memory and always turns on in the last mode set
/li>
• Waterproof and dustproof to IP68 standard
• Hardened ultra clear glass lens with anti-reflective surface

Power Modes:
Measured with 2500 mAh rechargeable NiMH batteries: 350 lumens: (2 hours)-> 100 lumens (7.5 hours)-> 50 lumens (16.6 hours)-> 8 lumens (80 hours)
Measured with included alkaline batteries: 350 lumens (36 minutes) -> 100 lumens (4 hours) -> 50 lumens (12 hours) -> 8 lumens (55 hours)

Use:
Fenix FD20 LED Flashlight To turn on, press the power switch located on the end of the flashlight. With the flashlight on, you can change power modes at any time by pressing the button (cycles through low - medium - high - turbo). The width of the cone is controlled by turning the ring on the flashlight barrel.

Warning
Do not disassemble the sealed parts in the flashlight barrel, this will void the warranty. Remove the batteries from the flashlight if you will not be using it for an extended period of time or if the batteries are already dead. This will prevent the risk of the batteries leaking and damaging the flashlight. If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The contacts inside the flashlight are clogged - clean them with a cotton swab dipped in alcohol. The head, body or back of the flashlight is loose - add lubricant to the sealing rings and tighten both the head and the end of the flashlight firmly.

Material: T6 aerospace hardened aluminium
Dimensions: 15.32 cm (length) x 2 cm (body diameter) x 2.54 cm (head diameter)
Weight: 87 grams (without batteries)
Lumen output: 350 lumens
Range: 115 m