FENIX E20 XP-E2 (265 lumenů) - LED flashlight

The second generation of the Fenix E20 XP-E2 LED flashlight offers a high lumen output of up to 265 lumens (ANSI) and a range of up to 210 meters. This version offers simplified controls and four levels of light output with up to 75 hours run time. Both control and switching are handled by the end button. It uses two commercially available pencil batteries for power; of course, disposable and rechargeable batteries can be used.

Thanks to constant current control electronics, it provides constant light output even when the battery voltage is reduced (when the batteries are slowly discharging). This flashlight is an ideal lighting tool with an excellent ratio of high performance, quality and price.

All flashlight parameters (lumen output, battery life, waterproof, range and shockproof) are measured in accordance with ANSI/NEMA FL 1-2009. The Fenix E20 XP-E2 flashlight replaces the older Fenix L2T V2.0, Fenix E20 and Fenix E21 models.

• Modern Cree XP-E2 LED with 50,000 hours of life
• Four power modes
• Digitally controlled for constant brightness
• Uses two pencil batteries (AA type - alkaline, lithium or rechargeable NiMH)
• Uses two AA type batteries/li>
• Batteries are inexpensive and widely available
• Protection against accidental insertion of the battery in reverse (reverse polarity)
• The flashlight is shockproof against falls from a height of 1 meter
/li>
• Bottom surface - Type III hard anodized
• Substantial surface grooves for better grip
• Memory to turn on in last set mode
• Waterproof to IPX-8 standard
/li>
• Hardened ultra-clear glass lens with anti-reflective surface
• Smooth aluminum reflector for a perfect light cone with a range of 210 meters

Power Modes:
Measured with 2500mAh rechargeable NiMH battery: 265 lumens: (1.4 hours)-> 95 lumens (6.75 hours)-> 35 lumens (22.5 hours)-> 8 lumens (75 hours)
Measured with included alkaline batteries: 265 lumens (30 minutes) -> 95 lumens (4.75 hours) -> 35 lumens (20 hours) -> 8 lumens (75 hours)

Use
Fenix E20 XP-E2 LED Flashlight To turn on, press the power switch located on the end of the flashlight. With the flashlight on, you can change power modes at any time by pressing the button (cycles through low - medium - high - turbo).

Warning
Do not disassemble the sealed part in the flashlight head yourself, it will void the warranty. Do not remove the batteries from the flashlight unless it will not be used for a long time or if the battery is already dead. Otherwise, some lower quality batteries may damage the flashlight. If the protective rubber rings appear damaged after extended use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water. If the flashlight flickers, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons: the batteries are almost dead - replace them. The contacts inside the flashlight are clogged - clean them with a cotton swab dipped in alcohol. The head, body or back of the flashlight is loose - add lubricant to the sealing rings and tighten both the head and the end of the flashlight firmly.

Material: T6 aerospace hardened aluminium
Dimensions: 15.4 cm (length) x 2.1 cm (body diameter) x 2.54 cm (head diameter)
Weight: 90 grams (without batteries)
Lumen output: 265 lumens
Range: 210 m