FENIX ATEX WF30RE - rechargeable flashlight

The professional rechargeable flashlight Fenix WF30RE is ATEX/IECex certified for use in explosive environments. Powered by a specially modified ARB-L21-2600Ex 2600 mAh Li-ion battery, the flashlight delivers up to 280 lumens with a range of 170 meters.

The battery is recharged directly in the flashlight using a special charger with safety circuitry. The body of the flashlight is made of aircraft aluminum with high durability and shock resistance.

The flashlight is designed especially for firefighters and rescue workers, it is also suitable as a work flashlight for industrial plants with the possibility of explosive dusts and gases. These include chemical plants, refineries, textile mills, paper mills, mills, metallurgical plants, power plants and other plants.

Certificates:

Useable in explosive gas zones 1-2 and explosive dust zones 21-22.
Full text of certificates:
IECEx: IECEx TUR 18.0042X:
Ex ib IIC T4 Gb
Ex ib IIIC T130°C Db
ATEX.

Included: Fenix ARB-L21-2600Ex rechargeable battery, mains adapter, charger with safety circuitry, wrist lanyard and spare o-ring.

• A powerful Cree XP-G2 neutral tint LED with a 50,000 hour lifetime is used.
• Four power modes: 280 lumens (6.83 hours) -> 120 lumens (15.66 hours) -> 30 lumens (120 hours) -> strobe (280 lumens).
• Uses a special Fenix ARB-L21-2600Ex Li-ion battery with a capacity of 2600 mAh. It is a modified 18650 type certified for explosive environments.
• The battery is recharged directly in the flashlight using a special charging adapter, it takes 5.5 hours to charge a fully discharged battery.
• The electronics is equipped with a protection function against too deep discharge of the batteries, when the voltage drops below a certain threshold, it automatically switches to a lower power mode.
• The flashlight has a memory and can be switched on in the last set mode (not valid for strobe).
• Indication of battery charge status.
• Made of A6061-T6 aerospace hardened aluminum.
• Hard scratch resistant finish - Type III hard anodized.
• Resistant to drops from a height of 1 meter.
• Waterproof and dustproof to IP68 standard (tested underwater at a depth of 2 meters for 30 minutes).
• Textured aluminum reflector for a perfect light cone with a range of 170 meters (7200 cd).
• Dimensions 15.05 cm (length) x 3.4 cm (head diameter) x 2.8 cm (body diameter).
• Weight 215 grams (including battery).

Light output: 280 lm
Range: 170 m

Controls:
The flashlight is turned on and off by holding the button on the side for 0.5 seconds. The light modes can be changed by briefly pressing the button in a low-medium-high cycle.
To activate the strobe, turn the flashlight on and then hold the button for 1.2 seconds. A short press of the button will then turn the strobe off again and the flashlight will return to the last mode used.
Battery charge indication - press the flashlight button (with the flashlight off). If the indicator LED is green the battery is more than 85% charged. Green flashing indicates 50-85% capacity. If it is red, it is 25-50% charged. Red flashing indicates that less than 25% of the battery capacity is left.
Discharged battery warning - the flashlight will automatically switch to the lowest mode and flash 3 times every 10 minutes.
Charging - plug the charger into the AC adapter and then into a power outlet. The indicator light on the charger will alternately flash red and green to indicate that it can be connected to the torch. Remove the rubber cap on the flashlight and plug the charger into the charging connector. The indicator light on the charger glows red while charging, and glows green when fully charged. After charging the flashlight, reseal the charging connector thoroughly with the rubber cap. Never charge the flashlight in an explosive environment.
To replace the battery, unscrew the flashlight end using an 8 mm inbus wrench. Never replace the battery in an explosive environment.

Caution:
Conduct all servicing, charging, and battery replacement outside of an explosive environment!
Use only the manufacturer-certified Fenix ARB-L21-2600Ex battery.
If the sealing rubber ring on the thread of the flashlight cap becomes damaged, replace it with the replacement from the flashlight package.
If the flashlight flickers, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons:
The battery is dead, charge it or replace it.